Ultimate Guide to the 200-301 - Latest Oct 31, 2022 Edition Available Now
2022 Updated Verified Pass 200-301 Exam - Real Questions and Answers
For more info read reference:
CCNA Official Certification Site
Security Fundamentals: This objective assesses the experience of the professionals in:
- Explaining wireless security protocols
- Verifying and setting access control lists
- Differentiating authorization, accounting, and authentication concepts
- Describing the elements of security programs (training, physical access management, and user awareness)
- Explaining the key protection concepts (exploits, vulnerabilities, and threats)
Programmability & Automation: The last area checks the competence of the individuals in:
- Describing characteristics of the APIs that are based on the REST
- Comparing traditional networks with controller-based networking
- Describing controller-based & software defined architectures
- Comprehension of the capabilities of configuration management mechanisms Ansible, Chef, and Puppet
- Understanding of JSON encoded information
NEW QUESTION 30
which type of IP address of ipv6 that also exist in IPv4 but barely used?
- A. anycast
- B. multicast
- C. broadcast
- D. unicast
Answer: A
NEW QUESTION 31
Refer to the exhibit.
A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network through port fa0/1. If any other device is detected, the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA, and then observes the output from these two show commands.
Which two of these changes are necessary for SwitchA to meet the requirements? (Choose two.)
- A. Port security interface counters need to be cleared before using the show command.
- B. Port security needs to be configured to allow only one learned MAC address.
- C. Port security needs to be globally enabled.
- D. Port security needs to be enabled on the interface.
- E. The port security configuration needs to be saved to NVRAM before it can become active.
- F. Port security needs to be configured to shut down the interface in the event of a violation.
Answer: B,D
NEW QUESTION 32
When configuring a WLAN with WPA2 PSK in the Cisco Wireless LAN Controller GUI, which two formats are available to select? (Choose two.)
- A. base64
- B. ASCII
- C. hexadecimal
- D. binary
- E. decimal
Answer: B,C
Explanation:
Section: Security Fundamentals
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/ b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_01010001.html
NEW QUESTION 33
Refer to the exhibit.
What is the next hop address for traffic that is destined to host 10.0.1.5?
- A. 10.0.1.4
- B. 10.0.1.50
- C. 10.0.1.3
- D. Loopback D
Answer: B
NEW QUESTION 34
What are two characteristics of a public cloud Implementation? (Choose two.)
- A. It enables an organization to fully customize how It deploys network resources.
- B. It is owned and maintained by one party, but it is shared among multiple organizations.
- C. It Is a data center on the public Internet that maintains cloud services for only one company.
- D. It provides services that are accessed over the Internet.
- E. It supports network resources from a centralized third-party provider and privately-owned virtual resources
Answer: D,E
NEW QUESTION 35
Which two command sequences must be configured on a switch to establish a Layer 3 EtherChannel with an open-standard protocol? (Choose two.)
- A. interface GigabitEthernet0/0/1
channel-group 10 mode active - B. interface GigabitEthernet0/0/1
channel-group 10 mode auto - C. interface port-channel 10
no switchport
ip address 172.16.0.1 255.255.255.0 - D. interface port-channel 10
switchport
switchport mode trunk - E. interface GigabitEthernet0/0/1
channel-group 10 mode on
Answer: A,D
NEW QUESTION 36
Refer to the exhibit.
If the network environment is operating normally, which type of device must be connected to interface FastEthernet 0/1?
- A. DHCP client
- B. PC
- C. router
- D. access point
Answer: A
NEW QUESTION 37
Assuming a subnet mask of 255.255.248.0, three of the following addresses are valid host addresses.
Which are these addresses? (Choose three.)
- A. 172.16.9.0
- B. 172.16.8.0
- C. 172.16.20.0
- D. 172.16.31.0
Answer: A,C,D
NEW QUESTION 38
Refer to the exhibit.
An access list is created to deny Telnet access from host PC-1 to RTR-1 and allow access from all other hosts A Telnet attempt from PC-2 gives this message:"% Connection refused by remote host" Without allowing Telnet access from PC-1, which action must be taken to permit the traffic?
- A. Remove the access-class 10 in command from line vty 0.4.
- B. Remove the password command from line vty 0 4.
- C. Add the ip access-group 10 out command to interface g0/0.
- D. Add the access-list 10 permit any command to the configuration
Answer: D
NEW QUESTION 39
Drag and drop the TCP/IP protocols from the left onto the transmission protocols on the right
Answer:
Explanation:
NEW QUESTION 40
What is a function of an endpoint on a network?
- A. allows users to record data and transmit to a tile server
- B. forwards traffic between VLANs on a network
- C. provides wireless services to users in a building
- D. connects server and client devices to a network
Answer: D
NEW QUESTION 41
Refer to the exhibit.
The default-information originate command is configured under the R1 OSPF configuration After testing workstations on VLAN 20 at Site B cannot reach a DNS server on the Internet Which action corrects the configuration issue?
- A. Configure the ip route 0.0.0.0 0.0.0.0 10.10.10.2 command on R2
- B. Configure the ip route 0.0.0.0 0.0.0.0 10.10.10.18 command on R1
- C. Add the default-information originate command onR2
- D. Add the always keyword to the default-information originate command on R1
Answer: D
NEW QUESTION 42
A Cisco IP phone receive untagged data traffic from an attached PC. Which action is taken by the phone?
- A. It allows the traffic to pass through unchanged
- B. It tags the traffic with the native VLAN
- C. It tags the traffic with the default VLAN
- D. It drops the traffic
Answer: A
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960x/software/15-0_2_EX/vlan/configuration_guid
NEW QUESTION 43
Refer to the exhibit.
A packet is being sent across router R1 to host 172.16.0.14. What is the destination route for the packet?
- A. 209.165.200.246 via Serial0/1/0
- B. 209.165.200.254 via Serial0/0/1
- C. 209.165.200.250 via Serial0/0/0
- D. 209.165.200.254 via Serial0/0/0
Answer: A
NEW QUESTION 44
When configuring an EtherChannel bundle, which mode enables LACP only if a LACP device is detected?
- A. Active
- B. Passive
- C. Desirable
- D. On
- E. Auto
Answer: B
Explanation:
The LACP is Link Aggregation Control Protocol. LACP is an open protocol, published under the 802.3ad.
The modes of LACP are active, passive or on. The side configured as "pasive" will waiting the other side that should an Active for the Etherchannel to be established.
PAgP is Port-Aggregation Protocol. It is Cisco proprietary protocol. The mode are On, Desirable or Auto. Desirable - Auto will establish a EtherChannel.
An example of how to configure an Etherchannel:
SwitchFormula1>enable
SwitchFormula1#configure terminal
SwitchFormula1(config)# interface range f0/5 -14
SwitchFormula1(config-if-range)# channel-group 13 mode ?
active Enable LACP unconditionally
auto Enable PAgP only if a PAgP device is detected
desirable Enable PAgP unconditionally
on Enable Etherchannel only
passive Enable LACP only if a LACP device is detected
NEW QUESTION 45
Refer to the exhibit.
To which device does Router1 send packets that are destined to host 10.10.13.165?
- A. Router3
- B. Router5
- C. Router4
- D. Router2
Answer: A
NEW QUESTION 46
......
Dumps Moneyack Guarantee - 200-301 Dumps Approved Dumps: https://www.dumpsmaterials.com/200-301-real-torrent.html
Verified 200-301 Exam Dumps PDF [2022] Access using DumpsMaterials: https://drive.google.com/open?id=14Kv3n35Tj_gCdvqToLbS4Mn7HxEVboYe
