2024 Realistic NSE7_SDW-7.2 Dumps Latest Fortinet Practice Tests Dumps
NSE7_SDW-7.2 Dumps PDF - NSE7_SDW-7.2 Real Exam Questions Answers
NEW QUESTION # 42
Refer to the exhibit.
Which statement explains the output shown in the exhibit?
- A. FortiGate must re-evaluate the session due to routing change.
- B. FortiGate performed standard FIB routing on the session.
- C. FortiGate will not re-evaluate the session following a firewall policy change.
- D. FortiGate used192.2.0.1as the gateway for the original direction of the traffic.
Answer: A
Explanation:
Explanation
The snat-route-change option is enabled by default. This option enables FortiGate to re-evaluate the routing
table and select a new egress interface if the next hop IP address changes. This option only applies to sessions
in the dirty state. Sessions in the log state are not affected by routing changes.
NEW QUESTION # 43
Which are two benefits of using CLI templates in FortiManager? (Choose two.)
- A. You can configure interfaces as SD-WAN members without having to remove references first.
- B. You can configure advanced CLI settings.
- C. You can configure FortiManager to sync local configuration changes made on the managed device, to the CLI template.
- D. You can reference meta fields.
Answer: B,D
NEW QUESTION # 44
What is the route-tag setting in an SD-WAN rule used for?
- A. To indicate the destination of a rule based on learned BGP prefixes.
- B. To indicate the routes that can be used for routing SD-WAN traffic.
- C. To indicate the routes for health check probes.
- D. To indicate the members that can be used to route SD-WAN traffic.
Answer: A
NEW QUESTION # 45
Refer to the exhibits.
Exhibit A -
Exhibit B -
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SD-WAN member status, the routing table, and the performance SLA status.
If port2 is detected dead by FortiGate, what is the expected behavior?
- A. The administrator manually restores the static routes for port2, if port2 becomes alive.
- B. FortiGate removes all static routes for port2.
- C. Host 8.8.8.8 is reachable through port1 and port2.
- D. Port2 becomes alive after three successful probes are detected.
Answer: B
Explanation:
This is due to Update static route is enable which removes the static route entry referencing the interface if the interface is dead
NEW QUESTION # 46
Refer to the exhibits.
Exhibit A shows the packet duplication rule configuration, the SD-WAN zone status output, and the sniffer
output on FortiGate acting as the sender. Exhibit B shows the sniffer output on a FortiGate acting as the
receiver.
The administrator configured packet duplication on both FortiGate devices. The sniffer output on the sender
FortiGate shows that FortiGate forwards an ICMP echo request packet over three overlays, but it only receives
one reply packet through T_INET_1_0.
Based on the output shown in the exhibits, which two reasons can cause the observed behavior? (Choose two.)
- A. On the receiver FortiGate,packet-de-duplicationis enabled.
- B. The ICMP echo request packets received over T_INET_0_0 and T_MPLS_0 were offloaded to NPU.
- C. The ICMP echo request packets sent over T_INET_0_0 and T_MPLS_0 were dropped along the way.
- D. On the sender FortiGate,duplication-max-numis set to3.
Answer: A,D
NEW QUESTION # 47
Which two performance SLA protocols enable you to verify that the server response contains a specific value?
(Choose two.)
- A. twamp
- B. icmp
- C. dns
- D. http
Answer: C,D
NEW QUESTION # 48
Refer to the exhibit.
Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)
- A. Set source 100.64.1.1.
- B. Set cost 15.
- C. Set load-balance-mode source-ip-ip-based.
- D. Set priority 10.
Answer: B,D
NEW QUESTION # 49
Refer to the exhibits.
Exhibit A -
Exhibit B -
Exhibit A shows the traffic shaping policy and exhibit B shows the firewall policy.
The administrator wants FortiGate to limit the bandwidth used by YouTube. When testing, the administrator determines that FortiGate does not apply traffic shaping on YouTube traffic.
Based on the policies shown in the exhibits, what configuration change must be made so FortiGate performs traffic shaping on YouTube traffic?
- A. Individual SD-WAN members must be selected as the outgoing interface on the traffic shaping policy.
- B. Application control must be enabled on the firewall policy.
- C. Web filtering must be enabled on the firewall policy.
- D. Destination internet service must be enabled on the traffic shaping policy.
Answer: B
NEW QUESTION # 50
Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)
- A. Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.
- B. All SD-WAN rules have the default setting enabled.
- C. The sdwan_service_id flag in the session information is 0.
- D. Traffic does not match any of the entries in the policy route table.
Answer: C,D
Explanation:
Explanation
sdwan_service_id is 0 = match SD-WAN implicit rule, study guide 7.0 page 120, 7.2 page 149 SD-WAN rules
internally are interpreted as a Policy route, so when the traffic doesn't match with any policy route, it will be
flowing by implict policy.
NEW QUESTION # 51
Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )
- A. A total of six packets are exchanged between an initiator and a responder instead of three packets.
- B. XAuth is enabled as an additional level of authentication, which requires a username and password.
- C. The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance.
- D. A peer ID is included in the first packet from the initiator, along with suggested security policies.
Answer: A,B
NEW QUESTION # 52
Which two statements about SLA targets and SD-WAN rules are true? (Choose two.)
- A. SD-WAN rules use SLA targets to check if the preferred members meet the SLA requirements
- B. SLA targets are used only by SD-WAN rules that are configured with Lowest Cost (SLA) or Maximize Bandwidth (SLA) as strategy
- C. Member metrics are measured only if an SLA target is configured
- D. When configuring an SD-WAN rule you can select multiple SLA targets of the same performance SLA
Answer: A,B
NEW QUESTION # 53
Refer to the exhibit.
Which conclusion about the packet debug flow output is correct?
- A. The original traffic exceeded the maximum packets per second of the outgoing interface, and the packet was dropped.
- B. The original traffic exceeded the maximum bandwidth of the outgoing interface, and the packet was dropped.
- C. The original traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.
- D. The reply traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.
Answer: C
NEW QUESTION # 54
Refer to the exhibit.
Which statement explains the output shown in the exhibit?
- A. FortiGate must re-evaluate the session due to routing change.
- B. FortiGate used 192.2.0.1 as the gateway for the original direction of the traffic.
- C. FortiGate performed standard FIB routing on the session.
- D. FortiGate will not re-evaluate the session following a firewall policy change.
Answer: A
Explanation:
The snat-route-change option is enabled by default. This option enables FortiGate to re-evaluate the routing table and select a new egress interface if the next hop IP address changes. This option only applies to sessions in the dirty state. Sessions in the log state are not affected by routing changes.
NEW QUESTION # 55
Refer to the exhibit.
Based on the exhibit, which two actions does FortiGate perform on traffic passing through port2? (Choose two.)
- A. FortiGate flushes all routing information from the session table, after a route change.
- B. FortiGate always blocks all traffic, after a route change.
- C. FortiGate does not change the routing information on existing sessions that use a valid gateway, after a route change.
- D. FortiGate performs routing lookups for new sessions only, after a route change.
Answer: C,D
NEW QUESTION # 56
Which components make up the secure SD-WAN solution?
- A. Datacenter, branch offices, and public cloud
- B. Telephone, ISDN, and telecom network.
- C. FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy
- D. Application, antivirus, and URL, and SSL inspection
Answer: C
NEW QUESTION # 57
Which three matching traffic criteria are available in SD-WAN rules? (Choose three.)
- A. Source and destination IP address
- B. URL categories
- C. Application signatures
- D. Type of physical link connection
- E. Internet service database (ISDB) address object
Answer: C,D,E
NEW QUESTION # 58
Refer to the exhibit.
Which conclusion about the packet debug flow output is correct?
- A. The original traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet
was dropped. - B. The original traffic exceeded the maximum packets per second of the outgoing interface, and the packet
was dropped. - C. The original traffic exceeded the maximum bandwidth of the outgoing interface, and the packet was
dropped. - D. The reply traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was
dropped.
Answer: A
NEW QUESTION # 59
What are two common use cases for remote internet access (RIA)? (Choose two.)
- A. Centralize security inspection on the hub
- B. Provide internet access through the hub
- C. Provide direct internet access on spokes
- D. Provide thorough inspection on spokes
Answer: A,B
Explanation:
B: Provide internet access through the hub: This involves routing branch or remote office internet traffic through a central hub, ensuring consistent security policies and possibly better management of network resources.
C: Centralize security inspection on the hub: With this approach, all internet-bound traffic from various spokes is inspected at the hub, leveraging centralized security mechanisms for thorough inspection and policy enforcement.
NEW QUESTION # 60
Refer to the exhibits.
Exhibit A shows the packet duplication rule configuration, the SD-WAN zone status output, and the sniffer output on FortiGate acting as the sender. Exhibit B shows the sniffer output on a FortiGate acting as the receiver.
The administrator configured packet duplication on both FortiGate devices. The sniffer output on the sender FortiGate shows that FortiGate forwards an ICMP echo request packet over three overlays, but it only receives one reply packet through T_INET_1_0.
Based on the output shown in the exhibits, which two reasons can cause the observed behavior? (Choose two.)
- A. On the sender FortiGate, duplication-max-num is set to 3.
- B. The ICMP echo request packets received over T_INET_0_0 and T_MPLS_0 were offloaded to NPU.
- C. The ICMP echo request packets sent over T_INET_0_0 and T_MPLS_0 were dropped along the way.
- D. On the receiver FortiGate, packet-de-duplication is enabled.
Answer: A,D
NEW QUESTION # 61 
Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2. The administrator configured ADVPN on both hub-and-spoke groups.
Which two outcomes are expected if a user in Toronto sends traffic to London? (Choose two.)
- A. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN.
- B. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
- C. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.
- D. London generates an IKE information message that contains the Toronto public IP address.
Answer: A,C
NEW QUESTION # 62
......
NSE7_SDW-7.2 Premium Exam Engine pdf Download: https://www.dumpsmaterials.com/NSE7_SDW-7.2-real-torrent.html
NSE7_SDW-7.2 Exam [2024] Dumps Fortinet PDF Questions: https://drive.google.com/open?id=1xYEWT7ABWiklVP5ivEHrcJZsu2INPiTE
