NS0-176 Braindumps PDF, Network Appliance NS0-176 Exam Cram
New 2021 NS0-176 Sample Questions Reliable NS0-176 Test Engine
NEW QUESTION 63
A disaster occurred and both Cisco UCS Fabric Interconnects must be replaced. You must restore the system from a "full state" backup.
Which two steps will accomplish this task? (Choose two.)
- A. Upgrade the new Fabric Interconnects to the same version of firmware as the previous Fabric Interconnects.
- B. Restore the "full state" backup using the UCS Manager "import configuration" wizard.
- C. Remove the current firmware from the new Fabric Interconnects.
- D. Restore the "full state" backup through the primary Fabric Interconnect's initial system setup wizard.
Answer: A,B
NEW QUESTION 64
Exhibit:
Referring to the exhibit, which two diagrams show the correct way to cable a new NetApp clustered Data ONTAP cluster with two nodes? (Choose two.)
- A. I
- B. IV
- C. III
- D. II
Answer: C,D
NEW QUESTION 65
Exhibit:
An administrator is configuring a NetApp 8-node AFF8060 system as part of a FlexPod solution and will be cabling the system based on the recommended guidelines shown in the exhibit.
Based on this information, which switch would be used for the cluster interconnect connections?
- A. NetApp CN1610
- B. Nexus 5596
- C. Nexus 5548
- D. NetApp CN1601
Answer: A
NEW QUESTION 66
After deploying a FlexPod solution, which tool would you use to validate a successful installation?
- A. Hardware Universe
- B. System Manager
- C. UCS Manager
- D. Config Advisor
Answer: D
NEW QUESTION 67
Your company has acquired a new NetApp EF600 storage array with a 25 Gbps HIC.
In this scenario, which FlexPod-supported protocol should be used to connect to this array?
- A. SMB
- B. NFS
- C. FC
- D. iSCSI
Answer: D
NEW QUESTION 68
Which two are required for single-wire management for Cisco UCS C-Series? (Choose two)
- A. Redundant Nexus 2232PP FEX
- B. UCS Manager 2.1 or higher
- C. 10 GB LOM
- D. VIC 1225
- E. VIC 1240
- F. FI 6200 family only
Answer: B,D
NEW QUESTION 69
You are deploying a new virtual machine (VM). Your customer requires that the VM cannot reserve space on the VMFS filesystem, and the VM can only consume blocks when data is written to disk from and within the VM/Guest OS.
Which virtual disk should you create to meet these requirements?
- A. Independent Nonpersistent
- B. Thick Provision Lazy Zeroed
- C. Thick Provision Eager Zeroed
- D. Thin Provision
Answer: D
NEW QUESTION 70
Your primary VSM needs to be edited, rebooted, or migrated. You need to initiate a manual switchover to your standby VSM.
What command will allow this to occur?
- A. vsm switchover
- B. System switchover
- C. System standby
- D. Standby activate
Answer: B
NEW QUESTION 71
A server administrator calls you complaining that an uplink on both UCS Fabric Interconnects went down. Each Fabric Interconnect has a vPC to the Nexus 500 switches.
After logging in to the switches, you notice that all vPC member ports on the secondary vPC peer switch are down. The vPC peer keepalive is still operational.
What is the problem in this scenario?
- A. The vPC feature is disabled.
- B. Both UCS Fabric Interconnects rebooted.
- C. The vPC peer link is down.
- D. A new VLAN was added to the UCS vPC member ports.
Answer: C
NEW QUESTION 72
To support Storage Virtual Machines, which type of unique login account must be created?
- A. vsadmin, for the cluster
- B. vsadmin, for each Storage Virtual Machine
- C. admin, for each Storage Virtual Machine
- D. admin, for the cluster
Answer: B
NEW QUESTION 73
When creating a virtual machine in VMware vSphere 5.x, which type of virtual disk should be provisioned if you would like to fully pre-allocate storage with the highest chance of being contiguous?
- A. Thick Provision Lazy Zeroed
- B. Thick Provision Eager Zeroed
- C. Full Provision
- D. Thin Provision
Answer: B
NEW QUESTION 74
Which statement is true for Fibre Channel QoS System Class?
- A. One can modify no-drop policy, and non FCoE traffic using natively the same class as FCoE will not be remarked
- B. One cannot modify no-drop policy, and non FCoE traffic using natively the same class as FCoE will be remarked to 0
- C. One cannot modify no-drop policy, and non FCoE traffic using natively the same class as FCoE will not be remarked
- D. One can modify no-drop policy, and non FCoE traffic using natively the same class as FCoE will be remarked to 0
Answer: B
NEW QUESTION 75
Which backup type stores Service Profile information as a small editable file?
- A. Full Backup
- B. All Configurations
- C. Logical Configuration
- D. System Configuration
Answer: C
NEW QUESTION 76
An administrator has a FlexPod solution with VMware vSphere 6.0. The VMware environment is using FCoE for storage connectivity for datastores.
Virtual machines running Windows Server 2012 R2 and RHEL have a requirement to use RDM LUNs for virtual machine storage. The administrator created an RDM LUN for a Windows 2012 R2 virtual machine and is currently creating an initiator group to map the LUN.
In this situation, which operating system should the administrator select for the initiator group?
- A. Linux
- B. VMware
- C. Windows
- D. Open VMS
Answer: C
NEW QUESTION 77
Which pool of addresses is created under Servers tab in UCS Manager as part of the Service Profile creation process?
- A. UUID Suffix Pools
- B. WWNN Pools
- C. MAC Pools
- D. WWPN Pools
Answer: A
NEW QUESTION 78
Exhibit:
Your customer has a FlexPod VMware solution deployed with NFS datastores. As shown in the exhibit, the links between the Fabric Interconnects and storage controllers are single-mode interface groups with autorevert set to true, hosting a single access LIF. NFS I/O is currently going through fabric A to ST-A. The customer wants to use both fabrics for NFS I/O.
In this scenario, what will accomplish this task?
- A. Configure VMware hosts to utilize an NFS LIF on ST-B that is connected to fabric A.
- B. Configure VMware hosts to use a new datastore with an NFS LIF on ST-B connected to fabric B.
- C. Migrate the existing LIF that is used for NFS I/O on ST-A to its HA partner ST-B.
- D. Add two physical links between SW-A and SW-B.
Answer: B
NEW QUESTION 79
Exhibit:
An administrator is building a FlexPod configuration with UCS 6296 Fabric Interconnect devices that support legacy Fibre Channel 9FC) connections. The administrator uses UCS Manager to configure the unified ports on the Fabric Interconnect.
Referring to the exhibit, how many ports will FC use after the configuration is completed?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION 80
An administrator has a Flexpod solution configured to use VMware vSphere 6.0. All virtual machines will reside on NAS datastores. Certain critical virtual machines have a requirement to use eager-zeroed thick provisioning.
In this scenario, which VMware capability should the administrator enable to satisfy the performance requirement?
- A. VMware VMFS VAAI
- B. Storage I/O Control
- C. NetApp NFS VAAI
- D. datastore clustering
Answer: A
NEW QUESTION 81
You are asked to verify your MPIO settings for your ONTAP FlexPod solution. You are using VMware ESXi 6 and FCP as the storage protocol.
In this scenario, which MPIO setting would you use on the ESXi host?
- A. fixed path with array preference
- B. fixed path
- C. round robin
- D. most recently used
Answer: C
NEW QUESTION 82
Which set of commands maps VLAN 100 to VSAN 100?
- A. Nexus 5000-A#configure terminal Nexus 5000-A (config) # vlan 100 Nexus 5000- A (config-vlan_ #fcoe vsan 100
- B. Nexus 5000-B# configure terminal Nexus 5000-B (config) # vsan database Nexus 5000-B (config-vsan)# vsan 100 Nexus 5000-B(config- vsan) #vsan 100 name FCoE-VLAN 100
- C. Nexus 5000-B# configure terminal Nexus 5000-B(config-vsan) # vlan 100 Nexus 5000-B (config-vsan)# vsan 100 name vsan100
- D. Nexus 5000-A#configure terminal Nexus 5000-B (config) # vsan database Nexus 5000-A (config)# vsan 100 Nexus 5000-A (config-vsan) # fcoe vsan 100
Answer: A
NEW QUESTION 83
Your customer needs a new Nexus switch that can support at least ten 40GbE ports, and has room for future growth. Your customer would also like the new switch to be Application Centric Infrastructure- ready.
Which switch meets these requirements?
- A. Nexus 6004
- B. Nexus 5672
- C. Nexus 9504
- D. Nexus 7004
Answer: C
NEW QUESTION 84
Which of the following tools is designed to inventory existing VMware vSphere, Linux, and Microsoft Windows Server versions in a customer environment?
- A. Microsoft Assessment and Planning (MAP) Toolkit
- B. Cisco Resource Comparison Tool
- C. Cisco UCS Sizer for Enterprise Applications
- D. Cisco UCS Central
Answer: A
NEW QUESTION 85
Exhibit:
You have a NetApp cluster and have just performed a storage failover giveback command from the CLI.
Referring to the exhibit, what is the status of the storage failover process?
- A. The giveback failed because cluster-01 was not able to communicate with the partner's cluster LIFs.
- B. The giveback is partially completed waiting for node cluster-02 to give back the partner's SFO aggregate.
- C. The giveback is partially completed waiting for node cluster-01 to give back the partner's SFO aggregate.
- D. The giveback failed because the partner node was not in a "waiting for "giveback" state.
Answer: B
NEW QUESTION 86
......
NetApp NS0-176 Exam Certification Details:
| Duration | 60 minutes |
| Exam Registration | PEARSON VUE |
| Sample Questions | NetApp NS0-176 Sample Questions |
| Exam Code | NS0-176 FlexPod |
| Number of Questions | 60 |
| Exam Name | Cisco and NetApp FlexPod Implementation and Administration |
| Passing Score | 68% |
| Exam Price | $150 USD |
Feel Network Appliance NS0-176 Dumps PDF Will likely be The best Option: https://www.dumpsmaterials.com/NS0-176-real-torrent.html
